Volume Flow Rate Converter

THE PRACTICAL GUIDE · NORMANDIN SYSTEMS

Get more from Volume Flow Rate Converter

Volume Flow Rate Converter expresses the same volume flow rate measurement in another unit. It is useful when a specification, worksheet, instrument, or reference uses a different scale from the one you need. One litre per minute equals 60 litres per hour, or 0.06 cubic metres per hour. The numerical value changes because the unit changes; the underlying measured quantity stays the same. A flow rate combines a volume unit with a time unit, so both parts must be converted. Gas flow may also depend on stated reference conditions. Enter the measurement together with its source unit, then read the equivalent in the destination unit. Keep the full result while doing subsequent calculations and round only when preparing the final report. A converted value cannot be more precise than the original measurement, even when the calculator displays many decimal places.

Guide updated October 13, 2026

How to use this tool

1. Find the l/min input row. If a metric-prefixed row is hidden, clear Exclude SI prefixes to reveal the supported prefixed units.
2. Enter 1 into the l/min row for the worked example. Editing a row recalculates the other supported unit rows automatically.
3. Read the m3/h row; the example should give 0.06 m3/h. Keep the unit label with the number when using it elsewhere.
4. Replace the demonstration value with your measurement, preserving its source unit and meaningful precision. Review the relevant physical assumptions before applying the converted value.

SEE IT IN PRACTICE

A worked example

1 L/min

0.06 m³/h

One litre per minute equals 60 litres per hour, or 0.06 cubic metres per hour.

A flow rate has two conversion factors

Volume per time combines a numerator and denominator. Changing litres to cubic metres changes one scale, while changing minutes to hours changes another in the opposite position. Write both factors before simplifying. To estimate a delivered volume, multiply the rate by a duration in the matching time unit; that calculation also assumes the rate remains representative throughout the interval.

Preserve fluid and reference conditions

A stated volumetric flow can depend on pressure and temperature, especially for gases. A value normalized to reference conditions is not automatically equal to an actual flow under different conditions. Unit conversion does not infer density, compressibility, or mass flow. Keep the fluid and reference-state information with the result when comparing instruments or using the number in an engineering calculation.

Converting both parts of a rate

A rate has a numerator and denominator. Moving from litres per minute to cubic metres per hour reduces the volume number by 1,000 and multiplies the time-related number by 60. Apply both changes. To estimate delivered volume, multiply the resulting rate by a duration expressed in the matching time unit and state whether constant flow is assumed.

When this tool is useful

• Prepare consistent volume flow rate values for fluid-system worksheets.
• Compare pump ratings with different volume and time units without mentally switching between unit systems.
• Check tank-filling estimates before adding a value to a report or calculation.

Tips for a better result

• A flow rate combines a volume unit with a time unit, so both parts must be converted. Gas flow may also depend on stated reference conditions.
• Use cubic metres per second as a common reference when comparing values from several sources; keeping one unit throughout a calculation makes dimensional errors easier to notice.
• Retain meaningful significant figures. Extra decimal places are useful for intermediate arithmetic, but do not imply that the original instrument measured with that precision.

Frequently asked questions