Creator design reference for Vinyl Siding Surface Mounting Block; included printed parts are specified in the listing.Design reference photo

Creator photo; included parts are listed below. Accessories not included.

Garden & outdoors / Printed garden accessories

Vinyl Siding Surface Mounting Block

3D printed in ASA for providing a shaped mounting surface on matching siding.

$44.99 CAD

Shipping within Canada is included in the listed price. Applicable taxes are calculated at checkout. Secure checkout for Canadian shipping addresses. Choose your quantity on Stripe. Shipping to the U.S.? Contact us for a shipping quote before ordering. U.S. shipping is an additional charge.

Check fit before ordering ↓

A closer look

3D printed in ASA for providing a shaped mounting surface on matching siding. Includes one printed mounting block. Hardware, devices, accessories shown and installation are not included.

Check the fit

Start with these details so you can choose the right part for your setup.

  • Compare the installation opening, clearances and separately supplied mounting hardware.

What’s included

  • One printed mounting block.
  • Hardware, devices, accessories shown and installation are not included.

Plan a level mounting area on matching siding

A shaped surface mounting block can help establish a deliberate mounting position where the siding profile would otherwise make a flat attachment awkward. Begin by identifying the item to be mounted, its contact area, and the exact siding section where it will sit. Check how the block will lie across the siding shape and whether nearby laps or trim affect the position. The useful result depends on the block matching that profile, so compare the actual wall rather than relying on the general description of vinyl siding. Also consider access around the mounted item for handling, cleaning, and any future removal.

Check the siding profile and attachment path

The approximately 168 × 168 × 38 mm measurements describe the printed block overall. They do not specify compatibility with every siding course, overlap, or wall assembly. Measure the siding shape and compare it with the back of the block, including where the block will make contact. Then check the face against the item's footprint and fixing positions. Plan where each fastener will obtain suitable support behind the siding and how any necessary penetrations will be handled. The block's thickness is only one part of that fastening path. Photos taken from the side, with a scale showing the siding profile, are especially helpful for checking a proposed installation.

Fit the block without using it to reshape the wall

Trial-position the block and confirm that it sits naturally before drilling or mounting the intended item. Avoid tightening fasteners merely to flatten an incompatible siding shape against the block. Follow the siding and mounted item manufacturers' installation requirements, including any relevant details for wall penetrations and moisture management. The ASA material and shaped form do not by themselves establish a weatherproof installation or a supported load. After installation, keep the visible edges accessible for inspection and gently remove accumulated dirt as needed. If the mounted item is later replaced with a different footprint or fixing pattern, reassess the whole arrangement instead of assuming the original block remains suitable.

Product questions

What does the listed price include?

One printed mounting block. Shipping within Canada is included in the listed price. Applicable taxes are calculated at checkout. Hardware, devices, accessories shown and installation are not included.

Will this match everything shown in the photo?

The creator photo is a design reference and may show other variants, quantities or accessories. The included-parts list describes exactly what this listing supplies.

Will it fit every vinyl siding profile?

No universal profile match is specified. Compare the course shape, overlap, and contact areas with the block. Side-on photographs and measurements of the actual siding provide the most useful starting point.

Does the block alone support the mounted item?

The complete fixing arrangement must provide appropriate support. Determine the supporting material behind the siding and the mounted item's requirements; the printed block does not establish a load rating by itself.

Can I use its outer size as a fixing template?

No. The outer dimensions describe the part, not fastener positions or a wall penetration pattern. Confirm the block geometry and the mounted item's actual holes before marking the installation.

Original design: MakerAker — Vinyl Siding Surface Mounting Block. MakerWorld model 2206635. Original design

Your cart

Ordering within Canada? Buy each product through its secure checkout, or ask us about combining parts into one order.

Your cart is empty. Find a useful part and add it here.