Design reference photoCreator photo; included parts are listed below. Accessories not included.
Rainwater Drainage Grille
3D printed in ASA for screening a matching drainage opening.
Shipping within Canada is included in the listed price. Applicable taxes are calculated at checkout. Secure checkout for Canadian shipping addresses. Choose your quantity on Stripe. Shipping to the U.S.? Contact us for a shipping quote before ordering. U.S. shipping is an additional charge.
Check fit before ordering ↓A closer look
3D printed in ASA for screening a matching drainage opening. Includes one printed grille. Hardware, devices, accessories shown and installation are not included.
Check the fit
Start with these details so you can choose the right part for your setup.
- Compare the installation opening, clearances and separately supplied mounting hardware.
What’s included
- One printed grille.
- Hardware, devices, accessories shown and installation are not included.
Match the grille to the drainage location
This printed grille is a candidate for screening a matching rainwater drainage opening. Begin by identifying the shape of the opening and the surface the grille would rest against. The useful comparison includes the supporting edge, seating depth and how the grille will be retained, not simply whether it can cover the visible hole. A well-planned position also lets you reach it for cleaning, because debris collected at a screen needs to be removed as part of the drainage area's normal upkeep.
Measure the seat separately from the outer outline
The approximate 126 by 175 by 23 mm bounds describe the whole printed part. Measure the actual receiving opening, the surrounding support and available depth separately so those external values are not mistaken for an internal fit. Photograph the location straight on and at an angle to show the seat. If an old grille is available, compare its underside and retaining arrangement, noting damaged sections. Include nearby paving, trim or downpipe features that might prevent the new grille from sitting flat or being lifted for maintenance.
Make debris removal part of the layout
Choose an arrangement that lets you inspect the grille without moving heavy stored items or dismantling an unrelated assembly. Observe what normally gathers at the location, such as leaves or other ordinary debris, and keep the screened area accessible for routine removal. The grille does not eliminate maintenance or establish a particular drainage flow rate. Follow the requirements of the drainage system itself and check the opening beneath as appropriate. A clean visible surface is not proof that a deeper part of the drainage route is clear.
Use it within the confirmed installation scope
ASA is the listed material, but material identification alone does not establish a pedestrian, vehicle or structural load rating. Confirm the intended location and support method before installation, especially where the part might otherwise be stepped on or driven over. Trial the fit gently and verify that the grille does not rock on an uneven seat. Check for movement, damage or collected debris during regular upkeep and after the area has been disturbed. If the support changes, reassess fit instead of relying on the previous seating position.
Product questions
What does the listed price include?
One printed grille. Shipping within Canada is included in the listed price. Applicable taxes are calculated at checkout. Hardware, devices, accessories shown and installation are not included.
Will this match everything shown in the photo?
The creator photo is a design reference and may show other variants, quantities or accessories. The included-parts list describes exactly what this listing supplies.
Can the grille be used where people walk over it?
No pedestrian load rating is established by this listing. Discuss the actual installation and use a suitably rated solution wherever the location requires support for people, vehicles or other loads.
Do the outside dimensions describe the opening it fits?
No. They describe the complete printed piece. Measure the receiving opening and supporting seat separately, including depth and any retaining features.
Will adding a grille remove the need to clean the drain?
No. Screening can leave debris collected at the opening, which still needs routine attention. Keep the grille removable or otherwise accessible through an appropriate installation and follow the drainage system's maintenance guidance.
Original design: ertux — rainwater drainage grid / griglia di scolo. MakerWorld model 1313640. Original design