Design reference photoCreator photo; included parts are listed below. Accessories not included.
10-inch Half-U Rack Blank — 3 mm Solid
3D printed in PETG for closing an unused half-U rack space.
Shipping within Canada is included in the listed price. Applicable taxes are calculated at checkout. Secure checkout for Canadian shipping addresses. Choose your quantity on Stripe. Shipping to the U.S.? Contact us for a shipping quote before ordering. U.S. shipping is an additional charge.
Check fit before ordering ↓A closer look
3D printed in PETG for closing an unused half-U rack space. Includes one solid 3 mm version blank panel. Hardware, devices, accessories shown and installation are not included.
Check the fit
Start with these details so you can choose the right part for your setup.
- Confirm your board, connector or rack dimensions and mounting-hole pattern before ordering.
What’s included
- One solid 3 mm version blank panel.
- Hardware, devices, accessories shown and installation are not included.
Give an unused rack space a deliberate finish
A blank panel is useful when a small rack layout leaves a visible gap that you want to close while keeping the equipment arrangement orderly. This solid half-U design can sit between compatible neighbouring panels or cover a reserved space until another component is fitted. Plan the blank as part of the rack layout so future changes remain straightforward. If you keep a port map or equipment diagram, mark the space as unused or reserved rather than treating the blank as an installed device.
Check the half-U space and mounting pattern
The panel is a 10-inch design, with approximate dimensions of 254 × 22.25 × 3 mm for the printed piece. The mounting-hole pattern and actual rail arrangement still need to match your rack. Check the clear gap between neighbouring panels, the fixing positions and the room for the chosen screw heads. Half-U placement may need particular attention when adjacent equipment already occupies nearby mounting points. Trial-position the blank without hardware first so you can see whether it aligns naturally rather than relying on screws to pull it into position.
Choose the gap with airflow and access in mind
This is the solid 3 mm version, so it closes the face of the selected space rather than providing a vent pattern. Consider the airflow and service access required by the surrounding equipment before covering a gap. Keep cables routed through suitable paths instead of pinching them behind a panel edge. Choose separately supplied mounting hardware that suits the rack and printed openings, and tighten carefully without bending the panel. A neat front face is useful when it supports the equipment layout, but it should not obscure a connection that you need to inspect regularly.
Keep changes simple as the rack evolves
Remove the blank when the space is needed and store it flat with its hardware labelled for later use. Wipe the front gently and check the fixing areas when reinstalling it. A printed blank is a cover, with no stated equipment-support or security function, so avoid hanging devices from it or using it as a shelf. If the rack arrangement changes, recheck clearance and airflow rather than assuming the previous position is still appropriate. This makes the panel a reusable layout component within the limits of the compatible rack interface.
Product questions
What does the listed price include?
One solid 3 mm version blank panel. Shipping within Canada is included in the listed price. Applicable taxes are calculated at checkout. Hardware, devices, accessories shown and installation are not included.
Will this match everything shown in the photo?
The creator photo is a design reference and may show other variants, quantities or accessories. The included-parts list describes exactly what this listing supplies.
Is this a vented blank panel?
No. The supplied design is the solid 3 mm version. Review the surrounding equipment's airflow requirements before using it to close a gap.
Does 10-inch width guarantee the fixing holes align?
No. Compare the mounting-hole pattern and the actual rail positions. The panel width alone does not confirm compatibility with every small rack.
Can I mount equipment directly to the blank?
No equipment-support rating is stated. Use a suitable tray or mount for devices and use this panel for its intended role of closing an unused rack space.
Original design: Mauker — 10-inch 1/2U Rack Mount Blanks. MakerWorld model 840793. Original design