Design reference photoCreator photo; included parts are listed below. Accessories not included.
18650 Single-Cell Project Holder
3D printed in PETG for positioning one 18650 cell in a custom electronics project.
Shipping within Canada is included in the listed price. Applicable taxes are calculated at checkout. Secure checkout for Canadian shipping addresses. Choose your quantity on Stripe. Shipping to the U.S.? Contact us for a shipping quote before ordering. U.S. shipping is an additional charge.
Check fit before ordering ↓A closer look
3D printed in PETG for positioning one 18650 cell in a custom electronics project. Includes one open single-cell printed holder; additional holders excluded. Electronics, batteries, metal contacts, fasteners, accessories shown and installation are not included.
Check the fit
Start with these details so you can choose the right part for your setup.
- Confirm your board, connector or rack dimensions and mounting-hole pattern before ordering.
What’s included
- One open single-cell printed holder; additional holders excluded.
- Electronics, batteries, metal contacts, fasteners, accessories shown and installation are not included.
Position one cell within a larger project
This open holder provides a defined physical location for one compatible 18650 cell in a custom electronics layout. It can be useful when planning how a single-cell project fits inside an enclosure or alongside a controller board. Start by drawing the intended arrangement and identifying where the cell needs to be accessed or removed. The open form makes the positioning concept visible, but it is only one component of the project. Electrical contacts, appropriate retention, insulation and the power system still need to be selected around the actual cell.
Measure the cell and the supporting components
The holder's approximate 24.56 × 78.52 × 18 mm outer measurements help establish its scale on a project base. They do not state the usable cell cavity or guarantee fit for every cell described as 18650. Compare the actual cell length, diameter and terminal profile, including any added protection features. Allow space for the separately chosen contacts and wiring at both ends. Also consider the motion required to insert and remove the cell: an enclosure wall or neighbouring board can block that movement even when the holder itself fits on the base.
Develop the layout before completing connections
Make the mechanical trial with the electrical system disconnected. Position the holder, contacts and other components so the cell can be fitted without force against its wrapper or terminals. Determine how the holder and cell will be secured for the project's actual use, rather than relying on the wires to keep them in place. Follow the chosen cell and electronics suppliers' requirements for charging and protection. If the project will need regular cell changes, provide a clear way to access the cell without lifting a circuit board or pulling on a soldered connection.
Inspect the fit during maintenance
When changing the cell, check the printed holder and the surrounding contact arrangement for damage or movement. Keep the open cavity clear of loose conductive debris and inspect any surface that touches the cell wrapper. This holder supplies no electrical function and has no stated sealing or containment rating, so use the complete project's requirements to decide on an outer enclosure and location. Clean the empty printed part gently with the electrical components disconnected and let it dry before reuse. Recheck the dimensions before substituting a different cell style.
Product questions
What does the listed price include?
One open single-cell printed holder; additional holders excluded. Shipping within Canada is included in the listed price. Applicable taxes are calculated at checkout. Electronics, batteries, metal contacts, fasteners, accessories shown and installation are not included.
Will this match everything shown in the photo?
The creator photo is a design reference and may show other variants, quantities or accessories. The included-parts list describes exactly what this listing supplies.
Does the holder include working battery terminals?
No metal contacts are supplied. The printed part positions a compatible cell; electrical contact and the rest of the power arrangement must be provided separately.
Can I build a multi-cell holder from this order?
This listing supplies one open single-cell holder. Any larger arrangement requires its own mechanical and electrical plan and the additional parts appropriate to that design.
Will a protected or button-top cell fit?
That requires a comparison with the actual cell and contacts. The 18650 name alone does not establish the completed cell length or terminal clearance.
Original design: Ning — 18650 battery case 21700 battery case. MakerWorld model 539919. Original design