Design reference photoCreator photo; included parts are listed below. Accessories not included.
Cable Raceway — 250 mm Printed Section
3D printed in PETG for routing cables along a surface.
Shipping within Canada is included in the listed price. Applicable taxes are calculated at checkout. Secure checkout for Canadian shipping addresses. Choose your quantity on Stripe. Shipping to the U.S.? Contact us for a shipping quote before ordering. U.S. shipping is an additional charge.
Check fit before ordering ↓A closer look
3D printed in PETG for routing cables along a surface. Includes one 250 mm printed raceway section with its matching cover. Hardware, devices, accessories shown and installation are not included.
Check the fit
Start with these details so you can choose the right part for your setup.
- Compare the opening, cable, shelf or mounting area with the listed design and dimensions.
What’s included
- One 250 mm printed raceway section with its matching cover.
- Hardware, devices, accessories shown and installation are not included.
Plan a straight cable route that remains reachable
A 250 mm raceway section is useful for organizing a short, defined run along a desk, bench, or other suitable surface. Begin by identifying where the cables need to enter and leave, then mark the route with the devices in their normal positions. This helps avoid a section that looks neat but ends just short of the actual connection point. Think about the side from which you will remove the cover during maintenance. If the section sits close to a shelf edge or another fixture, the cover may be awkward to reach even when the cable path itself fits. A reachable route makes later changes simpler than a tightly concealed one.
Measure length and cable clearance separately
The 250 mm description refers to the printed section length. The listed 250 × 48.83 × 12.7 mm component dimensions are overall bounding measurements, not a confirmed usable channel size or a finished installation allowance. Compare the actual raceway geometry with the cables you want to route, including their jackets, connectors, and bend requirements. A bundle that fits at one straight point may still need more room where the leads turn or leave the section. Check the surface for enough uninterrupted space and confirm the intended attachment method before installation. If the run is longer than one section, plan how adjacent sections will meet rather than assuming a continuous joint or corner fitting is supplied.
Load the section for future cable changes
Lay the cables in an order that makes their destinations easy to trace and leave slack where devices may move. Fit the matching cover without using it to force a crowded bundle into a smaller space. Cables should not be trapped at the ends or pressed sharply against the cover edge. Keep useful labels near accessible entry and exit points so you can identify a lead before opening the route. During later changes, support the cable group while removing the cover and inspect the PETG parts for damage or debris that affects seating. A closed cover provides a finished cable route, but it does not by itself establish weather sealing, electrical containment approval, or a cable strain-relief rating.
Product questions
What does the listed price include?
One 250 mm printed raceway section with its matching cover. Shipping within Canada is included in the listed price. Applicable taxes are calculated at checkout. Hardware, devices, accessories shown and installation are not included.
Will this match everything shown in the photo?
The creator photo is a design reference and may show other variants, quantities or accessories. The included-parts list describes exactly what this listing supplies.
How many cables can one section hold?
There is no verified cable-count capacity in the listing. Check the actual internal space against your cable diameters, the bends at each end, and the room needed to install and remove the cover comfortably.
Can it turn a corner?
This listing describes a straight printed section and matching cover. Plan any change of direction separately and confirm the intended joint or corner arrangement before ordering several sections for a longer route.
Can the route be opened after installation?
The product includes a matching cover, so leave practical access to that part when choosing the location. Confirm how the cover fits before mounting the section close to an obstruction or behind fixed furniture.
Original design: animuL67 — Cable Raceway. MakerWorld model 1867709. Original design