Design reference photoCreator photo; included parts are listed below. Accessories not included.
Corner Cable Duct with Cover
3D printed in PETG for routing cables neatly through a room corner.
Shipping within Canada is included in the listed price. Applicable taxes are calculated at checkout. Secure checkout for Canadian shipping addresses. Choose your quantity on Stripe. Shipping to the U.S.? Contact us for a shipping quote before ordering. U.S. shipping is an additional charge.
Check fit before ordering ↓A closer look
3D printed in PETG for routing cables neatly through a room corner. Includes one body and one matching cover. Hardware, devices, accessories shown and installation are not included.
Check the fit
Start with these details so you can choose the right part for your setup.
- Compare the opening, cable, shelf or mounting area with the listed design and dimensions.
What’s included
- One body and one matching cover.
- Hardware, devices, accessories shown and installation are not included.
Make a corner part of the planned cable route
A room corner can provide a convenient line for organizing cables when a loose run otherwise crosses an exposed surface. This body-and-cover set is intended for that corner-routing role. Trace the cable path from one connection point to the other and identify the short section the duct will organize. Consider how cables enter and leave it, where you need service access and whether furniture will hide the cover's removal path. A useful route remains understandable when equipment needs to move or a lead needs replacement.
Check the actual corner profile
Walls and furniture corners are not always perfectly square or free of trim. Look for a rounded joint, caulk bead, skirting detail or uneven surface that could prevent the body from seating as intended. The two printed components are approximately 200 mm long; their listed widths and heights describe separate component bounds, not the usable cable cavity. Compare the shape with the real corner and measure the intended cable bundle. Include room for the cover to close without pressing the cables into a smaller space than they naturally occupy.
Leave gentle transitions at both ends
The duct section is only one part of the route. Cables must enter and leave it without being pulled tight against an edge, so plan the transitions using the cable maker's bend guidance. Check whether a connector or strain-relief boot makes one end bulkier than the middle of the lead. If the cable continues behind furniture, leave enough practical access to inspect that transition later. Keeping connections outside inaccessible gaps makes routine device changes easier and reduces the amount of the layout you need to disturb.
Choose an installation you can service
Confirm an attachment method appropriate to both the mounting surface and the printed shape. Before fixing the body, test where your hand will reach to remove the matching cover. Place the cables, check their route and then seat the cover gently, reassessing any area that resists closure. When adding or replacing a lead, reopen the section and inspect the full bundle. This printed part organizes cables physically; it does not establish electrical raceway certification or alter the installation requirements of the equipment.
Product questions
What does the listed price include?
One body and one matching cover. Shipping within Canada is included in the listed price. Applicable taxes are calculated at checkout. Hardware, devices, accessories shown and installation are not included.
Will this match everything shown in the photo?
The creator photo is a design reference and may show other variants, quantities or accessories. The included-parts list describes exactly what this listing supplies.
Will it fit over a rounded or caulked corner?
That requires a profile check. Share photos and the shape of the actual corner, including any trim or bead, rather than assuming every corner presents the same contact surfaces.
Can the cables exit immediately into a tight bend?
Plan the exit around the requirements of the actual cable. Leave space for an appropriate transition and do not use the duct edge to force a cable into a sharper route.
How do I estimate how many cables it holds?
Measure the intended bundle and compare the usable interior, including cover clearance. The outside component bounds do not establish a cable count, especially when connector boots or mixed cable sizes are involved.
Original design: Catalan Printer — Corner Wall Cable Duct. MakerWorld model 1132212. Original design