Design reference photoCreator photo; included parts are listed below. Accessories not included.
Wheel Hub Cover — 56 mm Design
3D printed in ASA for covering a matching wheel hub opening.
Shipping within Canada is included in the listed price. Applicable taxes are calculated at checkout. Secure checkout for Canadian shipping addresses. Choose your quantity on Stripe. Shipping to the U.S.? Contact us for a shipping quote before ordering. U.S. shipping is an additional charge.
Check fit before ordering ↓A closer look
3D printed in ASA for covering a matching wheel hub opening. Includes one 56 mm design hub cover. Hardware, devices, accessories shown and installation are not included.
Check the fit
Start with these details so you can choose the right part for your setup.
- Compare your vehicle, mounting points and the exact component shape before ordering.
What’s included
- One 56 mm design hub cover.
- Hardware, devices, accessories shown and installation are not included.
Compare the wheel opening and retention features
Use the 56 mm design name as a starting reference, then examine the wheel opening that the cover must engage. Measure the receiving opening, available depth and any features that locate or retain the cap. A front-face diameter alone cannot establish fit because a cover may have a wider visible face and a smaller engagement area behind it. Photos of the wheel opening and both sides of an existing matching cap are useful. Check each relevant feature rather than inferring compatibility from the vehicle make.
Separate the appearance check from the fit check
A centre cover finishes a visible area of the wheel, so consider how the printed surface will look beside the wheel finish and any remaining caps. The approximate 65.5 by 65.5 by 15.5 mm bounds describe this individual printed part; they are not a replacement measurement for the stated design interface. Discuss the expected appearance and any finishing plans before ordering. A visual match and secure retention are separate requirements, and a good result needs both to suit the actual wheel.
Use the existing cap as a useful reference
If an original or previously fitting cover is available, photograph its underside before discarding it. Note the depth of the seating area and the locations of any retaining features, including damage that may explain why it no longer stays in place. If the old cap is missing, capture a close view of the empty opening with a ruler. Keep measurements from the visible face separate from those taken at the receiving edge so the two diameters are not confused during the comparison.
Check the installation after the trial fit
The ASA printed cover should be assessed gently against the confirmed opening before regular vehicle use. It must seat correctly by the intended attachment method without being forced against a mismatched feature. If retention is uncertain, stop and resolve the difference rather than assuming a tight press proves suitability. Inspect the cap during routine wheel cleaning for movement, damage or a changed seating position. Follow cleaning guidance appropriate to the printed material and wheel finish, and avoid directing removal force through an unsupported edge.
Product questions
What does the listed price include?
One 56 mm design hub cover. Shipping within Canada is included in the listed price. Applicable taxes are calculated at checkout. Hardware, devices, accessories shown and installation are not included.
Will this match everything shown in the photo?
The creator photo is a design reference and may show other variants, quantities or accessories. The included-parts list describes exactly what this listing supplies.
Why is the part wider than the 56 mm design name?
The individual-part bounds include its full exterior shape. A design interface and the visible outer face can be different measurements, so compare the receiving and retention features rather than using either number alone.
Will it fit every wheel on a particular vehicle?
No universal vehicle fit is established. Wheels fitted to the same vehicle can differ, so identify and measure the actual wheel opening and retaining arrangement.
Can I assess fit using a damaged old cap?
Often it still provides useful reference points. Show intact areas and identify damaged features clearly, then compare those observations with measurements of the wheel itself.
Original design: mxllner — Radnabendeckel / wheel hub cover 56mm diameter. MakerWorld model 1078225. Original design