Creator design reference for Cable Duct with Cover; included printed parts are specified in the listing.Design reference photo

Creator photo; included parts are listed below. Accessories not included.

Home organization / Practical pieces for your home

Cable Duct with Cover

3D printed in PETG for cable management.

$34.99 CAD

Shipping within Canada is included in the listed price. Applicable taxes are calculated at checkout. Secure checkout for Canadian shipping addresses. Choose your quantity on Stripe. Shipping to the U.S.? Contact us for a shipping quote before ordering. U.S. shipping is an additional charge.

Check fit before ordering ↓

A closer look

3D printed in PETG for cable management. Includes one cable duct bottom and one matching top. Hardware, devices, accessories shown and installation are not included.

Check the fit

Start with these details so you can choose the right part for your setup.

  • Compare the opening, cable, shelf or mounting area with the listed design and dimensions.

What’s included

  • One cable duct bottom and one matching top.
  • Hardware, devices, accessories shown and installation are not included.

Give a short cable run a defined route

A covered duct helps organize the part of a cable run that otherwise looks unfinished along a desk, panel or suitable interior surface. Decide where cables enter and leave before choosing the position. A short deliberate route is often easier to service than a route that hides every lead but leaves the connections difficult to reach. The supplied bottom and matching top form one duct section, making this a practical option to assess for a contained stretch of cable management rather than an unspecified length of channel.

Size the route for the actual cable bundle

Measure the cables together in the arrangement they will occupy, including any thicker sleeve or section near the connector. The listed part dimensions describe the printed pieces, not guaranteed usable interior capacity. The two components are each approximately 225 mm long, but their external width and thickness do not establish how many cables will fit. Allow the cover to seat without pressing on insulation and leave the cables enough space to follow their own bend requirements where they enter or leave the duct.

Plan access before fixing the bottom

Choose an attachment method suited to the surface and confirm that it works with the actual duct shape. Leave enough clearance to remove the top later without a shelf, monitor arm or neighboring panel blocking the movement. Think about which lead you are most likely to replace and whether its connectors can be handled at the ends of the route. Keep those service points accessible. Checking this before installation helps avoid a tidy-looking arrangement that has to be disturbed whenever one device changes.

Use the cover as part of a maintainable layout

Lay the cables in their intended route and check them before seating the cover. If the top resists, inspect the alignment and cable placement rather than compressing the bundle. Keep unrelated debris and spare hardware out of the duct. When equipment changes, reopen the section and reassess the route instead of pushing another lead into the available space. This is a printed cable-management accessory; any electrical installation requirements still belong to the selected cables, equipment and their approved installation method.

Product questions

What does the listed price include?

One cable duct bottom and one matching top. Shipping within Canada is included in the listed price. Applicable taxes are calculated at checkout. Hardware, devices, accessories shown and installation are not included.

Will this match everything shown in the photo?

The creator photo is a design reference and may show other variants, quantities or accessories. The included-parts list describes exactly what this listing supplies.

Do the outside dimensions tell me cable capacity?

No. They are individual printed-part bounds. Share the bundle measurements and cable shapes for an internal-fit comparison, and account for cover seating and the bends at both ends.

Can I add cables after installation?

Plan the mounting position so the matching cover can be removed for access. Recheck available space each time the bundle changes and avoid relying on the cover to compress extra cables.

Is this a certified electrical raceway?

The listing establishes a physical printed cable-management duct, not an electrical certification. Use it only within an arrangement appropriate for the cables and equipment, following their installation requirements.

Original design: fabian — Cable Duct. MakerWorld model 1032883. Original design

Your cart

Ordering within Canada? Buy each product through its secure checkout, or ask us about combining parts into one order.

Your cart is empty. Find a useful part and add it here.